I was also tried that in-band firmware burnning and eburn, too. eburn command possible if you can login into your ISR9024 switch with root account. I think eburn is very helpful when if you failed firmware update and your switch can't boot up normally...:)
I was mentioned about MTUSB-1 i2c connection device can debug and update firmware and EEPROM, too.
But that's not a general user prupose device and firmware updating is very long time consuming operation that above 45 minutes...:(
Anyway whenever you tried help me, I appriciate for hour kinds and passions.
I pray you have a nice journey with infiniband.
See you again...
Thank you...:)
from my iPhone
2013. 6. 25. 16:49 justinclift <socialmedia@mellanox.com> 작성:
Mellanox Interconnect Community
Mellanox (old Voltaire) ISR9024D-M recover flash area
reply from justinclift in InfiniBand/VPI Switch Systems - View the full discussion
I take this back. With further investigation, the "eburn" command seems to write firmware images to an EEPROM.
So, it's the same thing we already know how to do. Not much use.
Reply to this message by replying to this email, or go to the message on Mellanox Interconnect Community
Start a new discussion in InfiniBand/VPI Switch Systems by email or at Mellanox Interconnect Community
Following Mellanox (old Voltaire) ISR9024D-M recover flash area in these streams: Inbox