Hi,
I can move the slots, but when another card was installed in another
system with Fedora,
the self test gave the same answer after the firmware / driver were
upgraded.
If you think it is worth while I can change the slot.
We have just purchased 12 cards for distributed processing cluster and
so far all have
provided the same results.
Thanks,
Chet
Here is the full dmesg output on reloading the driver.
mlx4_core 0000:08:00.0: PCI INT A disabled
mlx4_core: Mellanox ConnectX core driver v2.4-1.0.0.1
(Feb 17 2015)
mlx4_core: Initializing 0000:08:00.0
mlx4_core 0000:08:00.0: PCI INT A -> GSI 32 (level, low)
-> IRQ 32
mlx4_core 0000:08:00.0: setting latency timer to 64
mlx4_core 0000:08:00.0: PCIe link speed is 8.0GT/s,
device supports 8.0GT/s
mlx4_core 0000:08:00.0: PCIe link width is x8, device
supports x8
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 82 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 83 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 84 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 85 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 86 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 87 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 88 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 89 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 90 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 91 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 92 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 93 for MSI/MSI-X
alloc kstat_irqs on node 0
mlx4_core 0000:08:00.0: irq 94 for MSI/MSI-X
mlx4_en: Mellanox ConnectX HCA Ethernet driver
v2.4-1.0.0.1 (Feb 17 2015)
mlx4_en 0000:08:00.0: Activating port:1
mlx4_en: eth6: Using 8 TX rings
mlx4_en: eth6: Using 8 RX rings
mlx4_en: eth6: Initializing port